FENDER SUPER SIX REVERB

FENDER SUPER SIX REVERB

1972-1979

Configuration: Combo
Power: 100-135 Watts
Effects: Reverb, Tremolo

SCHEMATIC

LAYOUT

  • Front Panel: "Normal" In, In, Bright Switch, Volume, Treble, Middle, Bass - "Vibrato" In, In, Bright Switch, Volume, Treble, Bass, Reverb, Speed, Intensity - Master Volume, Pilot Light
  • Back Panel: AC Outlet, Ground Switch, Fuse, Power Switch, Standby Switch, Speaker Jack, External Speaker Jack, Vibrato Jack, Reverb Jack, Reverb Out, Reverb In

CABINET 

SPEAKERS 

 TUBES

  • Pre amp: 7025
  • Power: 4 x 6L6GC
  • Bias: Fixed with Bias Pot
  • Rectifier: Solid State

Comments: Fender used the 4 ohm output transformer from the Twin even though the Super Six Reverb's speaker load was 5.2 ohms. A Line Out jack, hum balance pot, and a pull boost sw. were added near the end of the models run.

Back to FENDER FIELD GUIDE

2 comments

I have a 72 super six that has been frankensteind cut down to a combo size feature. It now has a 15 speaker instead of 6×10s .What ohms should be selected on the back panel?

Steven Jeffrey Runion,

Looking for help tracking my old telecaster circa 67. Serial number 185685 bought petty music pittsburgh

Allan knowles,

Leave a comment

Please note, comments need to be approved before they are published.